![]() ![]() Note we are not starting the vehicle, only turning the key one notch to power the electrical system.Īfter turning the key to the "OFF" position, remove it from the ignition. Now we're going to cycle the ignition once by turning the key to the "ON" position and then "OFF" again. Step 7: Turn the Ignition "ON" and "OFF," Then Remove the Key ![]() Once more, insert the key into the ignition, but this time leave it in. Step 6: Insert the Key Into the Ignition and Close the Driver’s Door Just like before, your door should end up open.Ĭlose the door, open the door, close the door, open the door. ![]() With your key still out of the ignition, we're going to close and re-open the door two more times. Step 5: Close and Open Driver’s Door Two More Times. With the door still open, take your key and without turning it, insert and remove it from the ignition switch ONCE within 40 seconds. Step 4: Insert and Remove Key From Ignition Once If your door wasn't open before starting, you might need to restart from step 1. With your key still out of the ignition, close and re-open your door twice, after which your door should still be open.Ĭlose the door, open the door, close the door, open the door. Step 3: Close and Open the Driver’s Door Twice Push the key in, take it out, push it in, and take it out. Take your key and without turning it, insert and remove it from the ignition switch twice within 40 seconds. Step 2: Insert and Remove Key From Ignition Twice Start by getting into the driver's seat and closing all of the doors, EXCEPT the driver's door-leave this one open.Īlso, ensure that all the doors are unlocked and that you have your key and fob with you. In a nutshell, you need to insert and remove the key from the ignition twice, close and open the door twice, and repeat this several times. I'm a huge Toyota fan, but I must say their key fob reprogramming procedure is a little ridiculous. Once you hear the locks cycle, your key fob should be programmed to your GM. This could take up to 30 seconds, so be patient. To program your keyless-entry remote, press and hold the "LOCK" and "UNLOCK" buttons on the key fob simultaneously until the locks cycle once more. You are now in programming mode! Step 5: Hold Down the “UNLOCK” and “LOCK” Button on Your Fob Within a few seconds, you will hear the locks cycle. Note we are not starting the vehicle, only turning the key one notch to power the electrical systems.Ĭycle the ignition twice by turning the key "ON"-"OFF"-"ON"-"OFF." Step 4: Release the “UNLOCK” Button on the Driver Side DoorĪfter cycling the ignition twice, release the "UNLOCK" button. Now we're going to cycle the ignition two times. While holding down the "UNLOCK" button on your door, insert your key into the ignition. Push down and hold the "unlock" button on your driver's side door-not to be confused with the unlock button on the fob.Ĭontinue holding down the unlock button. Step 2: Hold the "Unlock" Button on the Driver Side Door You'll need your car key and any fobs that you wish to program. Start by getting into your vehicle on the driver's side and close all the doors. ![]()
0 Comments
Leave a Reply. |